Support - How to Flash

QMK Toolbox

If you'd like to flash your keyboard, the easiest option is to utilize QMK Toolbox. Install it and then run it as an administrator (right click, go to Run as Administrator). Then go to the Tools menu and select Install Drivers. 

Get Firmware

Get your firmware, either from the Firmware Download page, or compile your own firmware. It is recommended to have the firmware ready to go before putting your keyboard into flashing mode.

Flashing

Click the Open button in QMK Toolbox and navigate to your desired firmware.

To put your keyboard in flashing mode, you can press the key combination Fn + Tab. After doing that, you won't be able to type with your keyboard anymore. You should see a message pop up saying "STM32 DFU device connected ... STM32 BOOTLOADER". That indicates your keyboard is in flashing mode.

Click the Flash button and it will transfer then verify the firmware. The keyboard will then restart on the new firmware and be back in normal operating mode.

Key Tester

If you made changes to the keymap, you can go to the Tool menu and select the Key Tester to bring up a large visible keyboard to show which keys are pressed and which ones have been used successfully.